PRODUCTS
EShop-number
Password
Welcome to CAIROX BELGIUM

FPA • Protectors

  • Cleaning products
  • Hydraulic systems
  • Protection products 

This protective agent in a pressurised aerosol can (C1 Fast Inhibitor 570916) protects the hydraulic system against corrosion and deposits. It ensures that the system continues to operate extremely efficiently and prevents frequent bleeding and cold points in the system. The protector can be used in new and existing heating and cooling systems at high and low temperatures. The protective agent is not aggressive and is therefore suitable for all materials used in hydraulic systems.

It is recommended to clean the system beforehand with the cleaning product CAB (C3 CLEANER 570911) or FCA (C3 FAST CLEANER 570915).

Brand

Caleffi

Application

To protect new and existing installations from corrosion and deposits.

Specifications

  • Aerosol spray can content: 0,4 l
  • The entire content of an aerosol spray can is sufficient to treat 150 litres of installation water (approximately 15 radiators or 120 m2 of underfloor heating).
  • Colour: straw yellow
  • Odour: light
  • pH: 8,2
  • Relative density: 1,1
  • Solubility (in water): soluble in hot and cold water
  • Use a double dose for installations filled with softened water.
  • There is no problem in case of overdose. In any case, it is preferable to overdose rather than underdose, as the treatment is no longer effective with underdosing.

Notes

Protection of existing and new installations :
Thanks to the adapter piece of the aerosol spray can, FPA can be added to the system by means of a dirt separator. To do this, proceed as follows:

! Switch off the circulation pump!

1. Drain the water from the dirt separator to remove any sediment.
2. Unscrew the hose connector of the dirt separator and tighten the spray can with the adapter piece. Open the drain tap of the dirt separator again.
3. Add FPA by pressing the button. The entire contents of the spray can are emptied in approximately twenty seconds.
4. Let the water circulate according to the schedule in the paragraph ‘Dosage’.
5. Drain the dirt via the dirt separator until clean water is obtained. Dispose of the waste water in accordance with the applicable regulations.
6. Fill in the label on the cap of the spray can and apply it to the heat pump.

Full instructions can be found in the manual under “Downloads”.
HELPCopyrightSales conditionsCookie policyAirvance Group

Requesting information. Please wait a moment...